Ridetech 11104099 - Manual (Page 2)

*** For Use With RideTech Rear Shock Kit ***
1. Raise and support vehicle at a safe and comfortable working height.
2. Support axle then remove coil spring and shock. Refer to service manual for proper disassembly
procedure.
3. The lower coil spring retainer must be
removed by cutting the welds. Grind all
sharp edges smooth.
4. Install airline fitting into airspring using
thread sealant. The airline will also need
to be routed at this time. Bolt the upper
cup bracket to the top of the airspring
using the two 3/8” nyloc nuts supplied.
5. Thread the 8” all tread into the nut at
the bottom of the cup and insert through
existing hole in the upper coil spring
pocket. This hole must be drilled open to
7/16”. Cut off extra threads
.
6. Use the 3/8” x 3 1/2” bolt and lower
plate to secure bag to the lower arm.
7. Install the new shock into the oem
location.
8. Make sure the bag cannot touch
anything through full suspension travel.