Ridetech 11054099 - Manual (Page 2)

Installation Instructions
******Must be used w/ RideTech shock kit******
1. Raise and support vehicle at a safe and comfortable working height.
2. Support axle then remove coil spring, shock, and bump stop. Refer to service manual for proper
disassembly procedure
.
3. Apply thread sealant to the air
fitting and screw it into the top of the
air spring.
4. Place the upper cup bracket on top
of the air spring and secure with two
3/8” Nylok nuts and flat washers.
5. Thread the 6” stud into the nut in
the bottom of the cup.
6. Place the air spring assembly into
the coil spring pocket with the tab on
the side of the cup aligning with the
factory bump stop mount.
7. The stud should poke through the
hole in the upper coil spring pocket.
Some cars may not have this hole and
it must be drilled. Fasten with a 7/16”
Nylok nut and flat washer.
8. Fasten the aluminum bump stop
spacer to the frame using a 3/8” x 1”
bolt, flat washer and lock washer.
9. Screw the bump stop into the
spacer.