Ridetech 11050999 User Manual
Page 2
Installation Instructions
******Must be used w/ RideTech shock kit******
1. Raise and support car at a safe, comfortable working height. Let the front suspension
hang freely
2. Remove coil spring and shock absorber. Refer to factory service manual for proper disassembly
procedure.
3. Insert air fitting into air spring using
tread sealant. Place the upper cup onto
the studs on the air spring and tighten
using two 3/8” nyloc and flat washers.
Thread the 6” stud into nut in bottom of air
spring cup.
4. Install air spring assembly into the coil
spring pocket with the tall side of the
bracket towards the wheel. With the stud
protruding through the OEM shock hole
secure the assembly with the supplied
hardware. (The airline must also be
routed at this time.)
5. The air spring will be attached to the
lower arm using a 3/8” x 3/4" bolt, lock
washer and flat washer.