Ridetech 11051100 User Manual

Page 4

Advertising
background image

5. Insert air fitting into air spring using
tread sealant. Place the upper cup onto
the studs on the air spring and tighten
using two 3/8” nyloc and flat washers.
Thread the 8” stud into nut in bottom of air
spring cup.

6. Install air spring assembly into the coil
spring pocket with the tall side of the
bracket towards the wheel. With the stud
protruding through the OEM shock hole
secure the assembly with the supplied
hardware. (The airline must also be
routed at this time.)

7. Bolt the lower Strong Arm to the frame
using stock fasteners. The air spring will
be attached to the lower arm using a
3/8” x 3/4" bolt.

8. Attach the shock to the upper mount
using the hardware kit supplied.

9. Insert the shock stud through the lower
shock eye and then place the aluminum
spacer onto the stud. The step on the
spacer will go into the arm. Slide the stud
through the lower arm and tighten.

10. Attach the adjustable steering stop to
the lower arm using two 5/16” x 1” bolts.
This can be adjusted to maintain tire/shock
clearances.

11. The sway bar end link must be
shortened to 2” tall optimize clearance and
alignment. Use the shorter 3/8” x 6 ½”
bolt supplied.




Advertising