Ridetech 11011099 - Manual (Page 3)

7. Bolt the lower air spring plate to the
lower arm using 3/8” x 1” bolts, flat
washers and Nylok nuts. The two outer
holes will align with the factory bump
stop holes. The inner two holes must be
drilled. Bolt the air spring to the lower
plate using 3/8” x ¾” bolts, flat washers
and lock washers.
8. Double check air spring clearance
through full suspension travel. If any
part of the air spring touches the frame
at anytime it will damage the unit. This
is not a warrantable situation.
9. The driving height of the car is
determined by the height of the air
spring. This air spring should be
approximately 5.5” tall at ride height.
This may vary slightly to driver
preference.