Installation instructions – Ridetech 11069000 User Manual
Page 2
Advertising
Installation Instructions
1
. Install the ¾” jam nut onto the end
of the Heim end, then screw Heim end
into the end of the panhard bar.
2. Press the aluminum T-bushings into
the Heim end. Fasten the Heim end to
the frame bracket using the 9/16” x 2
½” bolt and Nylok nut supplied.
3. Bolt the new panhard bar stud onto
the axle in factory stud location using
the 9/16” Nylok nut and flat washer
supplied.
4. Slide the rubber end of the panhard
bar onto the stud and secure with 5/8
”
thin Nylok nut and flat washer.
Advertising