Ridetech 11369100 - Manual (Page 2)

11369100 Installation Instructions
1. This sway bar is designed for use with RideTech lower StrongArms. It will not work
with other arms without modification.
2. Remove the factory sway bar. On trucks with a factory sway bar you will have to remove the
sway bar frame mount.
3. For 73-87
Bolt the new MuscleBar to the frame
rail using the poly bushing and bracket.
The rear hole for the factory sway bar
mount will be reused for the rear hole
in the new bracket. The front hole
must be drilled with a 3/8” bit. Four
3/8” x 1 ¼” bolts, Nylok nuts, and eight
flat washers will secure it to the frame.
3. For 63-72
Clamp the mount 2
¾” behind the
oval hole in the bottom of the frame.
Both of the holes for the sway bar
mount must be drilled with a 3/8” bit.
Secure the mount with four 3/8” x 1
¼” bolts, Nylok nuts and flat washers.