Ridetech 11249100 - Manual (Page 2)

11249100 Installation Instructions
1. This sway bar was designed for use with our lower StrongArms. Installation with other control
arms may require modification.
2. Remove the end links from the factory sway bar. Then remove the bolts attaching the sway bar to
the frame.
3. Bolt the frame plate to the frame
using the factory sway bar holes.
The front hole will use a 3/8” x 3/4"
flat head Allen screw. The rear hole
will use a standard 3/8” x 1 ¼” hex
bolt.
4. Using the bracket as a guide, drill
the front hole with a 5/16” bit and
thread with a 3/8”-16 tap.
Note: On some cars the factory bolt
holes may be 5/16” and will need to
be drilled and tapped to accept a 3/8”
bolt.
PDF created with pdfFactory trial version www.pdffactory.com