Ridetech 11239100 User Manual
Page 3
Advertising
7. Bolt the sway bar arm to the bar
using 3/8” x 1” Button head screws
with flat washers and lock washers.
8. Fasten the 90 degree end of the
PosiLink to the sway bar arm using a
3/8” flat washer on each side of the
arm and a 10mm Nylok nut.
9. Two T-bushing will be used on
each side to attach the straight end
of the PosLink to the lower control
arm. Secure with a 10mm Nylok
nut.
10. Install the thin ½” Nylok nuts on
the front bolt of the steering arm, and
cut off excess threads.
11. Check PosiLink alignment
through full suspension travel to
ensure that it does not bind.
PDF created with pdfFactory trial version
Advertising