Ridetech 11059100 - Manual (Page 2)

11059100 Installation Instructions
*****This sway bar is designed for use with our StrongArms******
1. Apply lithium grease to the
polyurethane bushing and slide it
over the sway bar.
Note: Do not use petroleum based
lubricants on polyurethane.
2. Place the frame bracket over the
poly bushing. Bolt the assembly to
the frame, the rear two holes in the
bracket will align with the factory
sway bar mounting holes.
3. Two of the three holes on the
front of the bracket will align with
existing holes. The outer hole must
be drilled to 7/16”.
4. Bolt the sway bar arm to the bar
using four 3/8” x 1” button head bolts
and lock washers. The holes in the
frame may need to be drilled out
slightly.
5. Attach the 90 degree end of the
PosiLink to the arm using a 12mm
Nylok nut.