Ridetech 19010500 - Manual (Page 2)

Installation Instructions
1. The upper shock mount must be
welded to the frame. It may need to be
cut down to match the stroke of the air
spring and suspension. Make sure that
when the suspension is fully
compressed that the shock is about ¼”
from being fully compressed.
2. Tack weld the mount during initial
fitment. The lower mount will be
installed to the back side of the lower
control arm.
3. Check to make sure the shock does
not bottom out when the suspension is
fully compressed. If the shock bottoms
out it could damage the shock or shock
mounts. Also check turning radius with
the wheel. Once the final location is
determined fully weld the upper mount to
the frame.