Ridetech 11390500 - Manual (Page 2)

350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
Installation Instructions
1. The shock bracket must be mounted
first. It bolts right behind the upper
arm and locates off the large hole in the
frame and in the bracket. The brake
line bracket must be removed and then
reinstalled over the top of the shock
bracket. The shock bracket is secured
with 1 ¼” x ⅜” bolts with Nylok nuts and
flat washers.
Note: There is a driver and passenger
side bracket. The picture shows the
drivers side.
2a. If using the factory lower arm; a
.625” hole must be drilled in rear leg of
the lower arm for the cantilever pin.
This hole should be approximately 9”
from the ball joint.
2b. If using lower StrongArm; the
cantilever pin will attach directly to the
tab welded to the rear leg of the
control arm.
3. Push the cantilever pin though the
bottom of the shock. Slide the
washer over the pin, then the
aluminum spacer. Fasten assembly
to lower arm w/ nut supplied.