Ridetech 11330607 - Manual (Page 2)

Installation Instructions
1. Place the new upper shock mount
against the frame, the tab in the front of
the bracket will slide into the factory
shock stud hole. Position the bracket
so that the bottom of the bracket is
parallel to the bottom of the frame.
Using the bracket as a template, mark
an drill four 3/8” holes in the frame rail.
Secure the bracket to the frame using
four 3/8” x 1 ¼” bolts, Nylok nuts and
flat washers.
2. Attach the shock to the upper
mount. See diagram on following
page.
Note: A notch must be made in the
inner fender well just above the mount
to allow clearance for the shock stud.
3. Attach the shock to the lower
control arm using the cantilever pin
supplied. See diagram on following
page.