Ridetech 11330600 User Manual
Page 2
Installation Instructions
1. Place the new upper shock mount
against the frame, the tab in the front of
the bracket will slide into the factory
shock stud hole. Position the bracket
so that the bottom of the bracket is
parallel to the bottom of the frame.
Using the bracket as a template, mark
an drill four 3/8” holes in the frame rail.
Secure the bracket to the frame using
four 3/8” x 1 ¼” bolts, Nylok nuts and
flat washers.
2. Attach the shock to the upper mount
using the new rubber bushings and
hardware supplied.
Note: A notch must be made in the
inner fender well just above the mount
to allow clearance for the shock stud.
3. Slide the lower shock stud through
shock, then install the aluminum
spacer. The step on the spacer will
face the lower arm. Secure the stud to
the lower arm w/ the ½” flat washer
and nut.