Ridetech 11220701 User Manual
Page 2
Advertising
Installation Instructions
1. Attach the upper T-bar to the frame
in the oem location using the supplied
3/8” x 1 ¼” USS bolts, washers and
Nylok nuts.
2. The bottom of the shock attaches
with the new cantilever pin supplied.
See diagram below.
Note: The hole in the axle bracket may
need to be drilled out to 5/8”
1. Cantilever pin
2. Aluminum bearing spacer
3. .625” bearing
4. Aluminum shock spacer
5. Factory axle bracket
6. ½” lock washer
7. ½” SAE nut
Advertising