Ridetech 11050500 - Manual (Page 2)

Installation Instructions
1. Position the upper shock mount on
the frame so the hole in the bracket
aligns with the hole in the side of the
frame and the tab is against the bottom
of the frame. You may have to trim some
of the inner fender well for clearance. On
manual shift cars you may have trim the
bottom of the Z-bar clutch bracket on the
driver’s side.
2. Mark the hole in the bottom of the
frame and drill with 5/16” bit. Use the
3/8” self-tapping bolts supplied and bolt
the bracket to the frame. Mark and drill
the remaining holes.
Picture shows alignment hole on side of
frame.