Ridetech 11010500 User Manual

Page 2

Advertising
background image

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Installation Instructions


1. Place the upper shock mount on the
corner of the frame behind the upper
control arm. Slide it forward until it
touches the rivet as shown the picture.
This is the driver side.

2. Use the bracket as a template to
mark and drill the two holes on top of the
frame. Secure the bracket with 7/16” x
1” bolts, nyloc nuts, and washers. Then
drill and bolt the one closest to the rivet,
and finish up on the rear hole.

Note: This kit was designed for use on
a two-piece frame. Installation on a one-
piece frame may require modifications.

3. Bolt the stud end of the shock to the
upper mount using the supplied
hardware.

4. Insert the shock stud through the
shock then spacer. The step in the
spacer should go through the arm.
Tighten the assembly with a nut on the
backside of the arm.

Note: If using the factory lower arm; drill
a 1/2" hole in the lower control arm
approximately 10" from the cross shaft
bolt.

Advertising