Ridetech 11392899 - Manual (Page 2)

Installation Instructions
3. Swing the lower StrongArm up to
the Shockwave and secure with the ½”
x 3 ¼” bolt and Nylok nut, an aluminum
spacer must be installed on each side
of the bearing.
4. Slide the ball joint boot over the
stud, then push the stud up through
the spindle. Secure w/ the new castle
nut and cotter pin supplied.
5. Grease the ball joints.
6. Lubricate the poly bushings with
Lithium grease.
1. After removing the factory lower
control arm, clean the bushing
mounting surfaces on the frame and
lubricate with Lithium grease.
2. Fasten the lower arm to the frame
with the factory hardware.