Ridetech 11343699 - Manual (Page 2)

Installation Instructions
1. Drop the ball joint down through
the upper control arm plate. Fasten
to the arm w/ the hardware supplied.
2. Fasten control arm to frame using
the stock hardware. Reuse the
alignment shims; however the truck
must be realigned after installation.
3. Slide the ball joint boot over the
stud, then insert stud through
spindle. Secure w/ new castle nut
and cotter pin supplied.
4. With the suspension at mid
travel, the upper cross shaft nuts can
be tightened.
5. Install Zerk fitting and grease ball
joint.