Ridetech 11326699 - Manual (Page 2)

Installation Instructions
1. The length of the upper bar
should be set from the factory at
11.125” center to center. Ensure
that the jam nut is tight.
2. Using the factory hardware, fasten
the heim end to the frame bracket.
An aluminum spacer must be
installed on each side of the Heim
end.
3. Fasten the other end of the bar to
the axle using the factory hardware.
Note: Inspect the rubber bushing in
the axle for wear or cracked.
Replace with factory replacement
bushing if needed.