Ridetech 11324499 User Manual

Page 2

Advertising
background image

Installation Instructions

1. Remove the sway bar (if
equipped) and factory lower trailing
arm. Do one side at a time to keep
the axle from rotating.

2. Clean bushing mounting surfaces
on frame. Lubricate w/ lithium grease
supplied.

2. Attach to front on the lower
StrongArm to the frame using factory
hardware.

3. This arm has holes in the tube for
sway bar attachment. Mount the bar
so that the holes are closest to the
axle.

4. Attach to rear of the lower
StrongArm to the frame using the
factory hardware.

Note: These polyurethane bushing
are lubricated at the factory w/ lithium
grease.

Note: Tighten the bolts enough to
remove any lateral movement and
apply moderate drag on bushings.
Over-tightening can cause excessive
suspension bind.

Advertising