Ridetech 11323699 - Manual (Page 2)

1. Fasten the upper arm to the frame
using the factory hardware. Reinstall
the current alignment shims, but
vehicle must be realigned.
2. Drop ball joint down through upper
arm. Slide ball joint boot over stud,
then place boot retainer over the boot.
Clamp assembly tight w/ the hardware
supplied.
3. Fasten the ball joint to the spindle
w/ the new castle nut and cotter pin
supplied.
4. Tighten the cross shaft nuts enough
to create drag on the poly bushings,
the arm should still move.