Ridetech 11283699 - Manual (Page 2)

Installation Instructions
Driver Side – Top View
1. Drop the ball joint down through
the ball joint plate, secure w/ the
hardware supplied.
2. Fasten the upper arm to the frame
using the factory hardware. Reinstall
the current alignment shims, but
vehicle must be realigned. This arm
was designed with an extra 2 degrees
of positive caster allowing the car to
be aligned with up to 4 degrees of
positive caster. (This will vary from
car to car.)
3. Insert the ball joint stud through
the spindle and install new castle nut
and cotter pin supplied.
4. Thread Zerk fitting into ball joint
and grease.
5. Position the suspension at mid
travel and then tighten the cross shaft
nuts.