Ridetech 11246699 - Manual (Page 2)

Installation Instructions
1. The length of the upper bar should
be set from the factory at 10.26”
center to center. Ensure that the
jam nut is tight.
2. Using the ½” x 3 1/2” bolt and
Nylok nut supplied, fasten the heim
end to the frame bracket. An
aluminum spacer must be installed
on each side of the Heim end.
3. Fasten the other end of the bar to
the axle using a ½” x 3 ½” bolt and
Nylok nut.
Note: Inspect the rubber bushing in
the axle for wear or cracked.
Replace with factory replacement
bushing if needed.