Installation instructions – Ridetech 11066699 User Manual
Page 2
Advertising
Installation Instructions
1. Bolt the upper StrongArm to the
frame using the 5/8” x 3 ½” bolts and
Nylok nuts supplied. An aluminum
washer must installed on each side of
the spherical bearing.
2
. Using a 5/8” x 3 ½” bolt fasten the
poly bushing end of the upper bar to
the axle bracket.
Note: Some vehicles have two factory
upper arms and need a second
tubular arm.
3. Install the ¾” jam nut onto the end
of the Heim end, then screw Heim end
into the end of the panhard bar.
4. Press the aluminum T-bushings into
the Heim end. Fasten the Heim end to
the frame bracket using the 9/16” x 2
½” bolt and Nylok nut supplied.
Advertising