Ridetech 11013699 - Manual (Page 2)

Installation Instructions
1. Remove the upper control arm and
cross shaft. The factory cross shaft will
be reused.
2. Place the larger sleeve over the end
of the upper cross shaft, slide the cross
shaft through the StrongArm. Then
press the bushing over the shaft. Insert
the smaller sleeve inside the bushing
and tighten the assembly with the 3/8”-
24 x 1 1/2" bolts.
3. Install the ball joint into the upper
StrongArm also facing down.
4. Bolt the upper StrongArm to the
frame and spindle using the factory
frame bolts.
5. The upper control arm bump stop is
reused.
6. Grease the ball joints.