Ridetech 11012899 - Manual (Page 3)

6. Grease the ball joints.
7. Double check air spring clearance
through full suspension travel.
If any part of the Shockwave touches
the frame at anytime it will damage the
unit. This is not a warrantable
situation.
4. Bolt the Shockwave or CoilOver to
the lower arm using the supplied 1/2" x
3 1/4" bolt and Nylok. An aluminum
spacer on both sides of the eye will
center the Shockwave.
Note: There are holes on the lower
arm near the ball joint to mount the
factory bump stop. Although, it is not
needed unless you are having tire
clearance issues.
5. Slide the ball joint through the
spindle and secure w/ castle nut and
cotter pin.
Driver Side