Ridetech 11220199 - Manual (Page 9)

6. Place the large lower air spring
plate over the lower coil spring
retainer.
7. Pull the piston down out of the air
spring and seat it on the lower coil
spring retainer. The center hub in the
piston should fit inside the retainer.
8. Some retainers may require
trimming to allow the air spring piston
to slide into the retainer.
9. Secure the air spring to the axle
using a 3/8” x 1” bolt, lock washer,
flat washer, and the 2 ½” washer.
10. Inflate the air spring and check
air spring clearance. If the spring
is allowed to rub on anything it will
cause failure, this is not a
warrantable situation.
14. This system will retain the
factory bump stop.
15. Driving height on this air spring is
approximately 8.5” tall, but may
slightly vary to driver preference.