Ridetech 11160109 User Manual
Page 6
Installation Instructions
1. After removing the factory lower
control arm, clean the bushing
mounting surfaces on the frame and
lubricate with lithium grease.
2. Fasten the lower arm to the frame
with the ½” x 3 ½” bolts and Nylok nuts
supplied.
Note: On some cars the frame
brackets may be pinched and will need
to be spread back apart to allow
bushing to slide in.
3. Swing the lower StrongArm up to
the Shockwave and secure with the ½”
x 3 ¼” bolt and Nylok nut, an aluminum
spacer must be installed on each side
of the bearing.
4. Slide the ball joint boot over the
stud, then push the stud up through the
spindle. Secure w/ the new castle nut
and cotter pin supplied.
5. Grease the ball joints.
6. Lubricate lower arm bushings w/
Lithium grease.