Ridetech 41262000 - Manual (Page 3)

9. Install the reinforcement plate
under the car. Secure the bracket
with 3/8” x 1 ¼” bolts, flat washers
and Nylok nuts.
10. Remove the door bars from the
mount.
10. Two more 3/8” holes must be
drilled into the kick panel. Install the
reinforcement plates and secure the
bracket with 3/8” x 1 1/4” bolts, flat
washers and Nylok nuts.
11. Reinstall the door bars.
Installation complete!
5. Remove the kick panel.
6. Temporarily bolt the floor mount
to the door bar using 3/8” x 1” bolts,
lock washers and flat washers.
7. Slide the door bar down the main
hoop until the floor mount contacts
the floor. The lower bar should also
be parallel to the floor pan. Tighten
the clamps.
8. Using the bracket as a template,
drill 4 holes through the floor pan.