Ridetech 41182000 - Manual (Page 3)

3. Assemble the clamps to the main
hoop. Use clamp P on the driver
side and clamp D on the passenger
side. Tighten the clamp enough to
be able to position it.
4. Use the ½” x 1 ½” 12 point bolt &
flange nut to fasten the door bars to
the clamps.
5. Position the door bar so that the
bottom of the upper clamp is 11 ¼”
above the main hoop flange. This
should position the door bar just
above the rocker.
5. To install the front floor pan
bracket, the kick panel must be
removed. To remove the kick panel
the parking brake assembly must be
removed. It will also help to remove
the dimmer switch. There is also a
bolt and clamp that attach the
parking brake to the floor pan that
must be removed.
6. Use the door bar to determine the
location of the floor pan mount. Drill
two 3/8” holes in the kick panel.
Place the reinforcement plate inside
the kick panel and secure the
assembly with two 3/8” x 1 ¼” bolts,
flat washers and lock washers.