Ridetech 41162000 User Manual
Page 3
3. Assemble the clamps to the main
hoop. Use clamp P on the driver
side and clamp D on the passenger
side. Tighten the clamp enough to
be able to position it.
4. Use the ½” x 1 ½” 12 point bolt &
flange nut to fasten the door bars to
the clamps.
8. Install the reinforcement plate
under the car. Secure the bracket
with 3/8” x 1 ¼” bolts, flat washers
and Nylok nuts.
9. Remove the door bars from the
mount.
5. Temporarily bolt the floor mount
to the door bar using 3/8” x 1” bolts,
lock washers and flat washers.
6. Slide the door bar down the main
hoop until the floor mount contacts
the floor. The lower bar should also
be parallel to the floor pan. Tighten
the clamps.
7. Using the bracket as a template,
drill 4 holes through the floor pan