Ridetech 41180000 - Manual (Page 9)

Air Ride Technologies
Package Tray
Bar (# 7090)
Drill Pilot
Holes
Trunk Bar
Frame
Rail
/”
Mounting
Plate
Reinforcement
Plate (709)
Reinforcement
Plate (60908)
Trunk Pan
Trunk Bar
Frame
Rail
7
41180000
70-73 Camaro TigerCage
Main Hoop Installation
Step . Align the four holes in the driver side
package tray bar, Part # 7090 with those
in the package tray. Insert four 3/8” x 1¼” hex
head bolts and washers through the package
tray bar, package tray and trunk bar. Secure
with four Nyloc nuts and washers (See Fig12).
Do not tighten yet.
WARNING:
When performing step 12 caution
must be taken not to puncture or damage any
fuel or brake lines while drilling through the
floor pan. Remove screws and clamps fasten-
ing the brake or fuel lines to the frame rail or
floor pan allowing them to be moved out of the
way. Both the driver and passenger sides lines
must be moved before drilling.
Step . Position the inside edge of the
mounting plate 1/2” from the spare tire well
(See Fig 13). Using the mounting plate as a
template, drill two pilot holes along the back
edge of the mounting plate. One through the
inboard hole and the other through the center
hole of the mounting plate. The inboard and
center mounting holes should straddle the
frame rail. If necessary adjust the mounting
plate to achieve the proper location and drill
six 3/8” holes through the trunk pan.
Step . Install two reinforcement plates
against the bottom of the trunk pan. The two
hole plate, Part # 60908, is mounted in-
board board of the frame rail and the four hole
plate, Part # 709 is mounted outboard of
the frame rail (See Fig 14). Secure both rein-
forcement plates to the trunk bar using six
3/8” x 1¼” hex head bolts, twelve washers and
six Nyloc nuts. Do not tighten yet.
Step . Repeat steps 7 through 13 for
installation of the passenger side package tray
bar Part # 7090 and trunk bar
Part # 70900.
Fig 
Fig 
Fig