Rocky Mountain Radar Phantom-T - Manual (Page 5)

Selectable Tones: The Phantom-T has selectable
tones. To change the tone of the unit, press and
hold the mute button down for 3-5 seconds for high
tone the unit will beep three times for low tone the
unit will beep one time.
Reminder! The Phantom-T will memorize the
settings of the features above when the unit is
powered off. Be sure to readjust the settings to
your normal preferences.
Power and Volume: Power is provided through
the thumb wheel switch on the left side of the unit.
Rotate the wheel forward to turn on and increase
the volume for the alarm.
Display shows: [P] [K] [Ka] [C] [2] [3] [4] [T]
[P] : Power
[K] : K Band Alert
[Ka] : Ka Band Alert
[C] : CITY Mode Display
[2][3][4]: Signal Strength LED
[T] : Scrambler Test LED
Alarms: LED Display when alerting
Laser -->All LEDs will flash together except for
[T] LED (In City Mode, [CITY] will flash as well).
K band--> [K] LED on and [2] [3] [4] will be on
one by one depending on the strength.
Ka band --> [Ka] LED on and [2] [3] [4] will be
on one by one depending on the strength.
Signal Strength:
Signal Strength Level 1: [K] or [Ka] LED will flash
Signal Strength Level 2: Signal strength LED [2]
will flash.
Signal Strength Level 3: Signal strength LED [2]
and [3] will flash.
More than Level 4: Signal strength LED [2], [3],
[4] will flash.
Alert beep will sound faster according to the
strength of signal.
Diagnostics: The Phantom-T has a full internal
automatic diagnostic system. If the power light
goes off and remains off, check the 2-amp fuse in
the power cord by unscrewing the silver tip and
removing the fuse. If the fuse is good (wire inside
the fuse unbroken), return the unit for service. 4