American DJ PRO-DJ1 - Manual (Page 9)

American DJ ® AUDIO •PRO-DJ1 INSTRUCTIONS MANUAL • PAGE 9
14. PITCH BENDING
• The speed increases or decreases respectively when the (+) PITCH BEND BUTTON (14) or PITCH BEND
(-) BUTTON (14) is pressed. The extent to which the speed changes is proportionate to the amount of time
the button is pressed. For example, if the PITCH BEND (+) BUTTON (14) is held in continuously, the speed
increases continuously.
• The pitch can be changed from range. See changing PITCH PERCENTAGE (17).
• The jog wheel will temporarily bend the pitch of the music if the song is already playing. Rotate the wheel
clock-wise to speed up or counterclockwise to slow down. The speed that you rotate the inner JOG WHEEL
determines the percentage (%) of the PITCH BEND.
15. PROGRAM PLAY
(1) Press the PROGRAM BUTTON (17) to make the unit enter the program mode in stop position. The
PROGRAM INDICATOR (27)LED above the PROGRAM BUTTON (17) will light as well as the PROGRAM
INDICATOR (27) on the LCD DISPLAY (13).
(2) Select a Track by using the TRACK BUTTONS (6/8), then press the PROGRAM BUTTON (19) again.
(3) Repeat this up to 30 times (ie. up to 30 tracks can be programmed). If you keep pressing the
PROGRAM BUTTON (17) the LCD DISPLAY (13)will display the tracks that have been programmed.
(4) Press the PLAY BUTTON (9) to begin playing programmed tracks.
(5) To cancel the program function press and hold PROGRAM BUTTON (17) for more than 2 seconds.
1. PRECAUTIONS ON HANDLING COMPACT DISCS
• Keep fingerprints, oil and dust off the surface of the disc. If the disc is dirty, wipe it off with a soft dry cloth.
• Do not use benzene, thinner, water, record spray, electrostatic-proof chemicals, or silicone-treated cloths to
clean discs.
• Always handle discs carefully to prevent damaging the surface; in particular when removing a disc from its
ends
• Do not bend the disc.
• Do not apply heat.
• Do not enlarge the hole in the center of the disc.
• Do not write on the label (printed side) with a hard tipped instrument such as a pencil or ball point pen.
• Condensation will form if a disc is brought into a warm area from a colder one, such as outdoors in winter.
•
Do not attempt to dry the disc with a hair dryer, etc.
2. PRECAUTION ON STORAGE
• After playing a disc, always unload it from player.
• Always store the compact disc in the jewel case, protecting from dirt or damage.
• Do not place discs in the following areas:
a) Areas exposed to direct sunlight for a considerable time.
b) Areas subject to accumulation of dust or high humidity.
c) Areas affected by heat from indoor heaters, etc.
CDS LEFT IN PLAYER
• If a CD is left in the player and the remote has been disconnected, plug power cable in, turn on power and take
out CD.• When you have finished using the CD player, and before switching off the power, be sure that the disc
holder has been closed with the OPEN/CLOSE BUTTON (1).
• TRAY PROTECTION: If tray is not closed after 60 seconds, it will close automatically and pause.
•
Do Not switch off the power when the disc holder is open.
• Switch off the power only after the disc tray has been closed with the OPEN/CLOSE BUTTON (1).
BASIC OPERATIONS (CONT.)
BEFORE SWITCHING OFF THE POWER
COMPACT DISCS