Speedtech Floater 9" Ford - Manual (Page 2)

Page 2 of 12
The following instructions are intended for professional installers
and are guidelines only.
Speedtech Performance assumes NO
responsibility for the installation of any of its products. All products are
intended for off road use only and must be installed by qualified professionals
only.
Thank you for purchasing your new Speedtech
Chicane Floater 9” Axle kit. Installing
this product will require the unbolting and removal of your rear suspension. Take all
necessary precautions whenever jacking up your vehicle and use safe and sturdy
jack stands to support the vehicle whenever it is off the ground. Be sure to take all
other safety precautions required to do the job correctly.
PARTS LIST

1-
9” Housing

2 - Axles

2- Park Brake backing plates

2- Corvette ZR1 hubs ( including axle retaining cap and 5 bolts each)

2- Brake caliper mounting brackets.

2- Wheel seals

1- Hub retaining bolt pack

1- Brake caliper mounting bolt pack.

1- Assembled third member (if you ordered the complete unit.)

2- Speedtech Sway Bar Heim style end links
Hardware List

8- 12 x 90 mm Control Arm Bolts

8- 12 mm Nylock nuts

4- 3/8 x 2 Fine Sway Bar End Link bolts

4- 3/8 Sway Bar End Link washers

4- 3/8 Fine Sway Bar End Link Nylock nuts

4- 3/8 x 3/4 Course Sway Bar End Link Bracket bolts

4- 3/8 Course Sway Bar End Link Nylock nuts