Auto Page RS-622 - Manual (Page 12)

12
1. Press and hold all four remote control buttons simultaneously
until one long beep is heard. Programming has now been
entered.
2. Within 5 seconds, press the button to select the mode of
vibration or melody, the icon will displayed on the LCD
screen to show the LCD remote transceiver is in vibration mode.
3. To exit programming mode, take no action for five seconds. The
remote control will generate two long beeps to indicate
programming mode has been exited.
Power Save Mode:
While in the power save mode, the LCD remote transceiver will “sleep”
until a button is pushed. This will extend the life of battery. When power
save mode is “ON”, the remote control will wake up periodically to check
for messages from the security module.
1. Press and hold all four remote control buttons simultaneously
unit one long beep is heard. Programming has now been
entered.
2. Within 5 seconds, press the button to toggle “On” or “Off”.
The remote will beep once for “On”, twice for “Off”. When power
save mode is “On”, the
icon on the LCD screens to
indicate entry the “power save mode”
3. To exit programming mode, take no action for five seconds. The
remote control will generate two long beeps to indicate
programming mode has been exited.
Screen Lamp ON:
Press the
button once and the LCD screen lamp will turn on for 5
seconds.
Clear the Flash Icon and Melody Sound:
Cycle the ignition then press the
button first, within 3 seconds press
and buttons at the same time. It will clear the flash icon and
melody sound on the LCD screen transceiver.
Stop The Trigger Melody Sound:
While triggering the alarm the LCD screen will alert the user through
melody sound and flashing trigger icon. Press any button on the LCD
remote transmitter to stop the melody sound.