Telenav for Sprint Supported Devices: v4.1 for Palm Treo 700p - Manual (Page 11)

© TELENAV 2003-6 PAGE 11 OF 30
TeleNav Bluetooth GPS Configuration
The GPS location information is provided by a
TeleNav Bluetooth GPS receiver, therefore you
must configure the GPS receiver before you can
access information that is dependent upon GPS
information in TeleNav.
Make certain that your TeleNav Bluetooth GPS
receiver is powered ON at this point during the
setup. Press Yes to configure the settings. A
scan of all nearby devices will be completed and a
list will be displayed. Highlight the TeleNav GPS
option and press OK to continue.
7. Addresses
This section discusses the variety of ways you can select a previously entered address, enter a new one, or use a
Business or Airport Address. This information is presented here since the techniques for setting addresses are
used throughout TeleNav.
Address Selector
TeleNav presents a list of options for you to choose from when a) setting a
destination address, b) setting an origin address, c) defining the center of a
displayed map, or d) anchoring a Business Finder search. These options
include: a) using an airport’s address, b) entering an address from the
keypad, c) verbally dictating an address to an automatic voice recognition
system, d) using the address of a business, e) using a Recent City, Recent
Stop, or a previously stored Location. One or more options may be omitted
from the Address Selector list depending upon the application context.
Recent Addresses
Recent Addresses are addresses used recently for navigation, directions,
business finder searches, or mapping. When the 24-item capacity of the list
is exceeded, the newest stop pushes the eldest off the list. When a stop in
the list is used within TeleNav, it is promoted to the head of the list.
Press Menu and select “Refresh” to pull in any addresses you entered on
the
www.TeleNav.com website Preplanning feature.