ASA Electronics DV2007 - Manual (Page 7)

DV2007
7
• Local / Distance Selector : Use the volume control knob to choose between Local or
Distance mode. This feature is used to designate the strength of the signals at which the
radio will stop during automatic tuning. "Distance" is the default setting, allowing the radio
to stop at a broader range of signals. To set the unit to select only strong local stations
during automatic tuning, turn the volume control knob until "Local" appears in the display.
• Rear Speaker On/Off (Rear Spk) : The rear speaker is turned “ON” by default. If “OFF” is
selected, the rear speaker's audio output will be TURNED OFF. Select “ON” to reactivate
output to the rear speakers.
• Programmable Turn-on Volume (VOL PGM) : This option allows you to select the
volume level the radio will automatically assume when turned on. "VOL PGM 12" is the
default setting. To program a specific turn-on volume level, use the volume control knob
(6) to select the a "VOLUME LEVEL” within 5 seconds.
• Beep Tone : The beep tone feature allows you to choose whether or not you hear an
audible beep tone when a button is pressed. "BEEP TONE On" is the default setting. Use
the volume control knob to select the "BEEP TONE Off" option.
AUDIO MENU
Press the volume control button (4) to access the Audio Menu. You can navigate through the
Audio Menu items by pressing the volume control button repeatedly, or by pressing the up >>|
(21) or down |<< (20) buttons. Once the desired menu item appears on the display, adjust that
option by turning the volume control knob within 5 seconds. The unit will automatically exit the
Audio Menu after five seconds of inactivity. The following menu items can be adjusted.
Volume Level
Use the volume control knob to adjust the Volume level from “00” (lowest) to “46” (highest).
Bass Level
Use the volume control knob to adjust the Bass level range from “-6” to “+6”.
Treble Level
Use the volume control knob to adjust the Treble level range from “-6” to “+6”.
Balance
Use the volume control knob to adjust the Balance between the right and left speakers from
“R12” (full right) to “L12” (full left). “C00” represents an equal balance between the right and left
speakers.
Fader
Use the volume control knob to adjust the Fader between the front and rear speakers from
“R12” (full rear) to “F12” (full front). “C00” represents an equal balance between the front and
rear speakers.
NOTE: When the rear speaker is turned off, the “FADER” option is disabled.
FRONT PANEL A/V INPUT
With a separately purchased 3.5mm A/V cable adapter , allows you to connect your
video,
game player, camera, video iPod, etc to this unit.
3.5mm A/V Cable ( not included )
Video
Right Audio
Left Audio
Ground
1
2
3
4
Connect the external device to A/V input jack
located at the front of the panel , then press
Mode button to select A/V input mode. Press
Mode Button again to cancel A/V input Mode
and return to previous mode.