Turbo Action 14156 Torqueflite 404, 413, 470 and Neon Manual Valve Body (PRN123) - Manual (Page 2)

Part #14156N 8/06/03, 05/30/07
STEP #8: Remove seven 10mm valve body bolts. There are three in front and four in the rear. You must hold valve
body up with hand while taking bolts out.
STEP #9: Carefully let valve body straight down. You may have to carefully pry governor tubes.
Note: Discard these tubes. (Fig. #6) Note: Some models have a bypass pipe, (Fig. 10 & 11).
STEP #10: Clean case and pan of dirt and R.T.V. sealant. (Most of these transmissions do not have a pan gasket)
STEP #11: If equipped remove Lockup Connecter and install Expansion Plug #U14040 (Fig. #2 & #7). If equipped with
cooler bypass (Fig. #10 & 11) you will have to block hole in case by taping hole 3/8”-16 and install the
#U23138 set screw.
STEP #12: Carefully slip new valve body back into transmission. Also, note alignment case pin will allow valve body to
go only one way. (Fig. #9)
STEP #13: Reinstall three (3) front bolts and four (4) rear. Tighten finger tight.
STEP #14: Now if valve body is flat, tighten all seven (7) bolts to 105 inch/pounds.
STEP #15: Align parking rod into valve body shift arm. Install “E” clip, be sure it is in place properly. (Fig. #5)
STEP #16: Install new filter #14010 (1981-82 three screws) or #14011 (1983-Up deep pan, two screws). Do not forget
filter gasket.
STEP #17: Install new pan gasket #14063C and oil pan. Be sure the magnet (if equipped) and the pan are clean.
STEP #18: Tighten all pan bolts to 165 inch/pounds. Do not over-tighten.
STEP #19: Lower car and install shift linkage (Fig. #1). Be sure it slides all the way down on the shaft. Just tighten
snug. Discard kickdown linkage.
STEP #20: Adjust kickdown band. Back off locknut and turn adjustment in until snug 10 inch/lbs. Then back off 1 1/2
turns. Tighten locknut without adjustment moving. (Fig. #2)
STEP #21: When using a funnel to fill transmission, be sure air can get around sides, otherwise oil cannot go in. Add
four (4) quarts.
STEP #22: Start engine and let idle for a couple of minutes. Now select all gears.
STEP #22: Put in Park and recheck oil level. Add oil if necessary to bring to add mark.
STEP #23: Take vehicle out and shift through the gears (PRN123) . Come back and recheck oil level.
CAUTION : Vehicles equipped with special gauge or light that indicates Low Transmission Pressure will require the
following:
After installing valve body, you must disconnect the wire at the transmission, which controls this indicator.
NOTE: This wire connects to a sending unit switch located on the radiator side of the transmission.
NOTE: There is also another sending unit switch the same side, but lower on the transmission. DO NOT
disconnect this one because it is for your neutral and park safety starting switch. (Fig. #2)
SPECIAL NOTE: Suggest taping end of wire that you disconnect so no possible chance of short -circuiting.
This valve body will not lock-up your lock-up converter if your vehicle has one!