Turbo Action 17999 Torqueflite 727, 904, 998 & 999 Tranz Brake (PRN123) - Manual

Part #17999 3/31/04 Page #1
Drill 1/16”
Ball Check
6/07/01, 1/18/02
The following must be done to maintain consistent staging with all Tranz Brake
Valve Bodies for Three (3) Speed Automatics: Before turning bottom final stage
yellow light on, you should be at a minimum of 1500 rpm to 2000 rpm. It also
helps to engage the tranz brake switch once before you begin to roll into the final
stage light. If you do this , in the late rounds when the transmission is hot, it will
have less tendency to roll in deep. Remember you must push the Tranz Brake
button then release the foot brake. If you do both at the same time, your car will
vary on the way it locks down, causing erratic reaction times. Transmission must
be full! Deep pans still must maintain natural full on dip stick!
Caution : Due to Higher Line Pressure some units will
blow Rear Clutch Piston Seal or bend the piston return
spring. The following should cure that problem.
Attention! Attention!
Attention! Attention! Attention!