Tuff Country 14985 - GM 00-06 K2500 HD 4wd 4 kit - Manual (Page 11)

92. Locate (2) 3/8” x 7” bolts and (2) 3/8” unitorque nuts from hardware bag 14985NB. Locate (2) S10067 sway bar
end link sleeves from hardware bag 14985SL. Also, locate (8) sway bar end link poly bushings and (8) sway bar end
link washers from hardware bag 14985PL. Special note: If you did not invert the stock sway bar in step # 10,
invert the stock sway bar now. Working on the driver side, install the new sway bar end link and hardware into the
stock location and torque to 32 ft lbs. Repeat procedure on passenger side.
93. Check and double check to make sure that all steps were performed properly and then check again. Check and
make sure that all new and stock hardware has been torqued to proper torque specification. Refer to the torque
specification at the end of the installation manual.
94. Take the vehicle directly to an alignment shop for a proper front end alignment.
Tuff Country EZ-Ride Suspension packages (2) sets of instruction sheets with this box kit. (1) is for the
installer and (1) is for the customer. The (1) for the customer has some post installation procedure literature
and it is the installers responsible to make sure that the customer receives a copy of the installation manual
along with the literature.
If you have any questions regarding the installation, please contact the technical department @ Tuff
Country. (801) 280-2777
Congratulations, installation complete. Check and double check to make sure that all steps were performed
properly. Check torque settings to make sure that all stock and new hardware has been torqued to proper
torque specifications
Also refer to the Vehicle owners manual for proper torque specifications on any stock hardware.
If you have any questions and/or concerns about the installation, please feel free to contact Tuff Country or
your local Tuff Country dealer.
Also refer to the Vehicle owners
manual for proper torque
specifications on any stock hardware.
Special post installation procedure: Tuff Country EZ-Ride Suspension highly recommends
adding a minimum of 1 pint, but no more that 1 1/2 pints, of proper front differential fluid
into the front differential. To achieve this, you may have to fill the differential with it on its
side or you may have to insert the fluid through the vend tube opening. On occasion, the
customer may find burping of fluid coming out of the front vent tube.