Tuff Country 30991 - Dodge Ram Performance Traction Bars - Manual (Page 4)

6. Place a hydraulic floor jack under the rear axle. Place one
on the driver and passenger side. Carefully raise up on both
hydraulic floor jacks until they make contact with the rear
axle.
7. Working on the driver side, loosen but do not remove the
rear u-bolts. Loosen just enough for the new rear traction bar
bracket to be installed between the u-bolts and axle. Repeat
procedure on the passenger side.
8. Locate the new rear traction bar brackets. Working on the
driver side, install the new bracket between the u-bolts and
the axle. Torque the u-bolts to 125 ft lbs. Repeat procedure
on the passenger side.
9. Remove the hydraulic floor jacks from under the vehicle.
Also, carefully lower the vehicle to the ground.