Tuff Country 32900 - Dodge 09-14 Ram 1500 4wd 2 lift kit - Manual (Page 7)

21. Working on the driver side, remove the track bar from the
track bar location. Save the hardware.
22. Carefully lower down on both hydraulic floor jacks allow-
ing enough room for the rear coil spring to be removed.
Working on the driver side, remove the rear coil spring and
set aside. Repeat procedure on the passenger side.
23. Locate the new rear coil springs spacers. Also, locate (2)
7/16” x 1 1/2” bolts, (4) 3/8” USS flat washers and (2) 7/16”
unitorque nuts from hardware bag 32102NB. Working on the
driver side, install the new 7/16” bolt into the upper coil
spring bucket. Hole provided. Then install the new rear coil
springs spacer into the upper coil spring bucket and secure
using the new hardware. Make sure to use loctite and torque
to 42 ft lbs. Repeat procedure on the passenger side.
24. Working on the driver side, install the coil spring back
into the OE location. Make sure that the OE rubber isolator
is installed with the coil spring. Carefully raise up on the
hydraulic floor jack until the coil spring seats properly into the
lower axle. Repeat procedure on the passenger side.
25. Install the track bar to the OE track bar mount and secure
using the OE hardware. Make sure to use loctite and torque
to 85 ft lbs.