Tuff Country 32909 - Dodge 2013 Ram 3500 4wd leveling kit (shock relocation bracket) - Manual (Page 3)

Hardware bag 32909NB includes:
Description Quantity
9163B (9/16” x 3” bolt) 2
12WA (1/2” USS flat washer) 4
916UN (9/16” unitorque nut) 2
381B (3/8” x 1” bolt) 2
516WA (5/16” USS flat washer) 4
38UN (3/8” unitorque nut) 2
Please follow instructions carefully:
Before installation begins, measure from the center of
the hub, to the bottom of the fender well, and record
measurements below.
Pre-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
At the end of the installation take the same
measurements and compare to the pre-installation
measurements.
Post-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Front end installation:
1. To begin installation, block the rear tires of the vehicle so
that the vehicle is stable and can’t roll backwards. Safely lift
the front of the vehicle and support the vehicle with a pair of
jack stands. Place a jack stand on both the driver and the
passenger side. Next, remove the front wheels and tires
from both sides.
2. Place a pair of hydraulic floor jacks under the front axle.
Place one on the driver side and passenger side. Carefully
raise up on both hydraulic floor jacks at the same time until
they come into contact with the front axle.
3. Working on the driver side, remove the shock from the
vehicle and save the upper and lower hardware. Repeat pro-
cedure on the passenger side.
4. Working on the driver side, remove the sway bar end link
from the sway bar. Save the hardware. Repeat procedure on
the passenger side.
5. Carefully lower down on both hydraulic floor jacks at the
same time allowing enough room for the new coil spring
spacer to be installed. Special note: Take special care not
over extend any brake lines or hoses.
6. Working on the driver side, remove the coil spring from the
vehicle and set aside. Repeat procedure on the passenger
side.
7. Working on the driver side, remove the coil spring isolator
from the upper coil spring pocket and set aside. Repeat pro-
cedure on the passenger side.