Tuff Country 36005 - Dodge 03-07 Ram 2500 / 3500 6 kit (with front coil springs) User Manual
Page 3
Before installation begins, Tuff Country EZ-Ride
Suspension highly recommends that the installer
performs a test drive on the vehicle. During the test
drive, check to see if there are any uncommon sounds
or vibrations. If uncommon sounds or vibrations occur
on the test drive, uncommon sounds or vibrations will
be enhanced once the suspension system has been
installed. Tuff Country EZ-Ride Suspension highly
recommends notifying the customer prior to installation
to inform the customer of these issues if they exist.
New longer front and rear shocks are needed after this
suspension system has been installed and the front and
rear shocks need to be ordered as a separate part #. If
you have not already ordered your front and rear
shocks, please feel free to contact Tuff Country or your
local Tuff Country dealer and order your front and rear
shocks. Tuff Country recommends installing a 30” fully
extended nitrogen gas shock in the front and a 33” fully
extended nitrogen gas shock in the rear.
After completion of the installation, Tuff Country EZ-
Ride Suspension highly recommends that the installer
informs the customer that whenever they have their
vehicle lifted in the air by the frame rail, the front sway
bar end links need to be disconnected from the stock
sway bar. If this is not done, damage will occur to the
stock front end links.
Special note: Before installation begins, it is the
customers/installers responsibility to make sure that all
parts are on hand. If any parts are missing, please feel
free to call one of our customer service representatives
@ (801) 280-2777.
Recommended tools selection:
Cut off wheel
Sawzall
Torque wrench
Standard socket set
Standard wrench set
Metric socket set
Metric wrench set
Tape measure
Hydraulic floor jacks
Hardware bag 36000NB1 includes:
Description
Quantity
9166B (9/16”x 6” bolt)
1
916512B (916” x 5 1/2” bolt)
1
916312B (9/16” x 3 1/2” bolt)
1
9164B (9/16” x 4” bolts)
2
12WA (1/2” USS flat washer)
8
SUW-916 (9/16” u-bolt harden washer)
2
916UN (9/16” unitorque nut)
4
124B (1/2” x 4” bolt)
1
716WA (7/16” USS flat washer)
2
12UN (1/2” unitorque nut)
1
716112B (7/16” x 1 1/2” bolt)
4
38WA (3/8” USS flat washer)
8
716UN (7/16” unitorque nut)
4
M1480B (14 mm x 80 mm bolt)
1
M14WA (14 mm flat washer)
2
S10107 (fender washers)
4
38112B (3/8” x 1 1/2” bolt)
6
516WA (5/16” USS flat washer)
12
38NLN (3/8” Nylon lock nut)
6
Hardware bag 36005SL includes:
Description
Quantity
S10059 (.875” x .550” x 2.370”)
4
S10060 (.875” x .640” x 2.630”)
4
S10061 (1.130” x .610” x 2.270”)
1
S10062 (1.130” x .610” x 1.330”)
1
34000-07 (nut bracket)
1
Hardware bag 34000PL includes:
Description
Quantity
MO2617 (control arm bushing)
16
MO3509 (front upper shock bushing)
2
M03510 (front upper shock bushing)
2