Tuff Country 43801 - Jeep Cherokee 87-01 3.5 EZ-Flex kitt - Manual (Page 6)

11. Locate the new EZ-Flex control arms. Set each control
arm to 16 1/2” from the center of eye to the center of eye.
12. Working on the driver side, install the new EZ Flex lower
control arm into the OE location using the OE hardware.
Special note: Make sure that when installing the new
lower control arms the sert fitting are facing the upward
position. Do not tighten at this point. The lower control
arm hardware will be torqued once the weight of the vehicle
is on the ground. Repeat procedure on the passenger side.
13. Locate the new track bar relocation bracket. Install the
new bracket into the OE track bar pocket.
14. Locate (1) S10048 sleeve from hardware bag 43800SL.
Secure the new track bar relocation bracket to the OE pock-
et using the OE hardware and new sleeve. Do not tighten
at this point.