Tuff Country 52008 - Nissan Titan 1.5 Leveling Kit - Manual (Page 5)

14. Locate the stock lower sway bar end link hardware.
Working on the driver side, install the stock end link into the
stock location and secure using the stock hardware. Make
sure to use thread locker or loctite and torque to 42 ft lbs.
Repeat procedure on the passenger side.
15. Locate the stock upper control arm mounting hardware.
Working on the driver side, attach the stock upper control
arm to the stock knuckle and secure using the stock nut.
Special note: A cheater bar may be needed to pull the
upper control arm down so that it can be attached to the
stock knuckle. Repeat procedure on the passenger side.
16. Working on the driver side, torque the stock upper con-
trol arm nut to 95 ft lbs. Repeat procedure on the passenger
side.
17. Locate the stock upper control arm cotter pins. Working
on the driver side, install the stock cotter pins into the stock
location. Special note: If the stock cotter pins can not be
installed, tighten the stock upper control arm nut some more
until the stock cotter pin can be installed. Repeat procedure
on the passenger side.
18. Move back to the new hardware attaching the stock strut
into the stock upper location and add some thread locker or
loctite and torque the (3) nuts to 38 ft lbs. Repeat procedure
on the passenger side.
19. Check and double check to make sure that all steps were
performed properly and check again.
20. Install the tires and wheels and carefully lower the vehi-
cle to the ground.
Congratulations, installation complete!
Special note: After the completion of the installation,
Tuff Country EZ-Ride Suspension recommends taking
the vehicle to an alignment shop and having a proper
front end alignment performed.
Tuff Country EZ-Ride Suspension recommends that a
complete re-torque is done on all bolts associated with
this suspension system. It is the customers responsibil-
ity to make sure that a re-torque is performed on all
hardware associated with this suspension system after
the first 100 miles of installation. It is also the customers
responsibility to do a complete re-torque after every
3000 miles or after every off road use. Neglect of follow-
ing these steps could cause brackets to come loose and
cause serious damage to the suspension system and to
the vehicle.
Tuff Country EZ-Ride Suspension packages some post
installation procedure literature and it is the installers
responsibility to make sure that the customer receives a
copy of the installation manual along with the literature.
If you have any questions or concerns, please feel free
to contact Tuff Country or your local Tuff Country deal-
er.