Yetter 2984 Series Maverick HR Plus - Manual (Page 5)

5
BOLT TORQUE
Note: Right hand and left hand designations are based on sitting in the tractor and facing forward.
READ THESE INSTRUCTIONS FIRST:
1. Improperly tightened bolts will result in damage, breakage, expense, and down time.
2. Always replace bolts with the specified grade and type.
3. Torque properly before first use of the machine and every 2-4 hours of use until you are sure bolts
are staying tight.
4. The chart below is a guide for proper torque. Use it unless a specified torque is called out
elsewhere in the manual.
5. Torque is the force you apply to the wrench handle or the cheater bar, times the length of the
handle or bar.
6. Use a torque wrench whenever possible.
The following table shows torque in ft. lbs.
Lubricate all bearings and moving parts as assembled and make certain that they work freely.
WARNING:
Never work around the toolbar / implement while in a raised position
without using safety lockups.
CAUTION:
The MAVERICK OPENER™ and its attachments are very heavy. Extra
attention to lifting techniques while handling and or maneuvering the opener during
assembly. Failure to do so may lead to personal injury.