Yetter 6300 Coulter Cart - Manual (Page 13)

13
ASSEMBLY INSTRUCTIONS
Toolbar Hanger Assembly
STEP 12. Install the 2 ½” x 8” hydraulic cylinder base end and clevis to the toolbar hanger using the 6 5/8”
cylinder pin and 3/16” x 2” cotter pins. Attach the rod end of the cylinder to the coulter toolbar cylinder lug
using the 3 ¾” pin and 2) 7 ga. hairpin clip.
STEP 13. Remove the port plugs from the 2 ½” x 8” hydraulic cylinders and install the 90 deg. hose fitting.
Attach the 3/8” x 22” hose to each fitting. Connect the two hoses attached to the base end of the cylinders
using a tee hose fitting and also connect the hoses attached to the rod end of the cylinders. Now connect
the 3/8” x 150” hoses to the tee fittings and route the hoses toward the drawbar clevis. Install the tip
adaptors to the tractor end of the 3/8” x 150” hoses.